Application Guide for POSTMOULD Graphics

Operator Friendly Application
"You'll Like Our Speed"

		Carefully preheat area to which graphic is to be applied with a wide flame torch. Ensure even heating by using brush-type strokes back and forth.  When a slight gloss appears (surface oxidation) and the plastic is slightly too hot to briefly touch proceed to next step.
		Place graphic face-up on heated area.
		Roll firmly over the complete graphic area.
		Carefully peel release paper from graphic. If the graphic sticks to the paper, lay flat and use roller again.  Make sure no bubbles remain.  If bubbles are present, pierce with sharp instrument, roll again.
		Carefully flame applied graphic once more to embed into plastic.
		It is that easy!
Download Complete Application Instructions In PDF Format